![]() ![]() ![]() If one router is used to support multiple sites then each site would share the same management broadcast domain. Network segmentation of your management VLAN is recommended per site. VLAN tags remain on frames until a switch or router removes them.If local administration is not possible for a disconnected device then resetting the device to defaults and re-configuring it may be required.Using a management VLAN can mean losing administrative access to the equipment from the LAN port with some equipment (Cambium manufacturer that has addressed this by using 169.254.1.1 form the LAN for local only administration).In my opinion, management should be available by physically plugging into the management interface on your router or using a VPN to login to your management network. I recommend that your infrastructure is inaccessible from the internet and from your customers. Also any other manufacturer of managed switches should be able to use VLANS for port isolation. VLANs should be able to perform port isolation in the switch chip on your MikroTik switches. Bridge port horizons work well to keep the software bridges from broadcasting between customer access ports on your customer gateway but they require CPU processing of the packet so they are not desirable for MikroTik switches. Note: Bridge horizons should be used on MikroTik routers but VLANs should be used on MikroTik switches for port isolation.If using VLANs on a PoE switch this may be the VLAN interface on ether1 `ether1-VLAN103` IE: `/interface bridge port add interface=ether1 bridge=Customers horizon=1`. Unless you need peer-to-peer communication, it is recommended to set the bridge horizons to isolate the customer interfaces on your customer access router.Adding a customer access bridge can be done like: IE: `/interface bridge add name=Customers`. If for no other reason then to be able to test the customer access with a tech port. I recommend using a customer access bridge on your customer access router (customer’s gateway) even if only intending to use a single router port.If you are using an individual router port per AP with individual subnets then the following can be skipped. It is a personal preference but I don’t prefer to use individual customer access subnets per access point.I use numbers above 199 for VLANs that may be passing through a switch or other special use.Accept management from management networks.Accept ICMP from all (you can limit ICMP per second).Input chain Firewall rules on access routers.It can be helpful to configure a ‘tech port’ for VLAN 10 switchport access.I prefer management only on the wireless interface and on VLAN 10.I recommend blocking all management access except from the approved sources on all infrastructure.The horizons work like a one way valve just like client-isolation on the AP, blocking broadcasts between interfaces on the same horizon. Use bridge horizons on your router’s bridge with the same horizon on each AP interface (ethernet or VLAN interface).Use bridges and bridge horizons on your router.Using VLAN 101 for switchport 1 and VLAN 102 for switchport 2 makes administration and configuration simpler in my opinion. I like to use a convention of map switch ports to specific VLANs to simplify configuration.When multiple AP’s are within the same VLAN use Port Isolation on the AP ports (not the router port).Switch ports that connect to AP’s should be isolated.Repeating broadcast messages between subscribers increases network load and can allow for rogue DHCP servers or other broadcast services to exist on the network which are supposed to only work within a LAN. This reduces load and improves reliability. Avalara Tax Configuration for Set-up Fee.Enable Avalara in the Subscriber’s Account.Change or Update Subscriber Internet Speed.Automate reset of Speed Limits for Wireless Services.Allow Customers to Create Their Passwords.Enable Email Notification for New Signups.Lock Transactions: Activate and Configure.Add Scheduled Actions (Reschedule Late Fee / Suspension).Enable Automatic Payment of Invoices to.How to display reports on the dashboard?.Aw Snap, Timeouts, or Out of Memory Errors. ![]() Setting up and Managing Application Users. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |